First, before converting the file to a mesh (STL file), check to see if the file is a closed polysurface or an open polysurface. If you have a polysurface in Rhino and you would like to know if it can be printed there are a few things that can be done to check this. Note: These following methods primarily apply to the 3D modeling software Rhino. Sometimes the only way to make a file printable is to recreate it altogether. They may be able to correct the file, but please note that this is not always the case. If you are unable to successfully create a file, contact a lab assistant for further help. While the methods described below will aid in creating a printable model, sometimes a file is too complex to be printable. One of the more difficult tasks when it comes to 3D printing is creating a clean file. After the print is complete, the structural support is removed by placing it in a chemical bath for around 12 hours. Print times can range from 1 hour up to 24 hours. Models with a wall/column thickness less than 0.04″ or 1 mm are printed at the student’s own risk and expense. The uPrint SE Plus build volume is 8″x8″圆″ – while the Stratasys 170s have a build volume of 10″x10″x10″. ![]() The College currently has five ABS printers, which operate in the same manner, but have different build volumes. ![]() All 3D Print Lab assistants are available for consultation and walk up file preparation/execution during their posted shifts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |